Size Guide: L-shaped & sectional slipcovers

L-shaped & sectional slipcovers

Each section gets its own cover. Measure each section twice: its length, then its depth.

Measure every section separately. Follow the sofa's surface, over any armrest or backrest on the path. Keep the tape against the fabric. Two numbers per section: length across, depth front to back.

L-shaped sofa

2 sections shown · 2 covers
A A B B C C D D
  • A
    A–A · chaise lengthFront edge of the chaise, along the seat, up to the top of the backrest.
  • B
    B–B · chaise depthOuter edge of the chaise seat straight across to where it meets the sofa.
  • C
    C–C · sofa lengthFrom where it meets the chaise, along the seat, over the arm to its outer edge.
  • D
    D–D · sofa depthFront edge of the seat, back over the cushion, up to the top of the backrest.

Use each section's length to pick its size below. Then check its depth against the range at the bottom.

Match EACH section's length to a size

1 Seat
35–57
inches
90–145 cm
2 Seats
57–75
inches
145–190 cm
3 Seats
75–93
inches
190–235 cm
4 Seats
93–118
inches
235–300 cm
↑
Right on the line between two sizes? Go up.Stretch fabric grips a slightly smaller sofa fine. It will not reach across a larger one.
Also check each section's depth
Z BACKFRONT
Z · Section depth
27.6–37.4 in
70–95 cm · applies to every size

Measure straight from the back of the section to its front edge.

Length picks the size, but the cover also has to reach front to back. If a section is deeper than this range, the cover will pull up short at the front even when the length is right.

Example: two sections, two different sizes

A–A measures 65 in
about 165 cm · depth checked
Choose 1 × 2-seat cover
+
C–C measures 82 in
about 208 cm · depth checked
Choose 1 × 3-seat cover

Add each cover to your cart separately.

For this stretch slipcover's listed sizes. Inch conversions are approximate.